None of this needs to be bought at once. Building a complete kit over time, prioritising the areas most exposed in a typical fall, is a realistic way to get there.
Anti fog inserts and coatings help in cold or wet conditions, but they are not a substitute for a visor in good condition. Once scratches build up to the point where they catch the light on every ride, it is time to replace rather than keep cleaning around the problem.
ECE 22.06 is the current European standard that motorcycle helmets are tested against, and it replaced the older ECE 22.05 standard with a wider and more demanding set of tests. Helmets are checked for impact absorption at multiple points on the shell, not just the crown, and the standard also tests rotational forces, which earlier standards largely ignored.
A made to order helmet starts long before any material is cut. Measurements are taken, the intended use of the helmet is discussed, and a rider works with the maker to settle on a shell, lining and finish that suit them specifically, rather than picking from fixed stock sizes.
Any impact, including a helmet dropped from a moderate height, can compress the inner liner in ways that are not visible from outside. A helmet is designed to absorb one significant impact by sacrificing that inner material, so a helmet involved in a crash should always be replaced, not inspected and reused.
To see gloves and accessories that pair with our helmets, visit full face helmet.